Description
Product Overview
The Rear Brake Drum serves as a vital component of the vehicle’s rear braking and emergency/parking system. When the foot brake or handbrake is activated, the hydraulic wheel cylinder forces the brake shoes outward into contact with the inner working surface of this rotating cast-iron drum, generating the friction necessary to decelerate or hold the vehicle safely.
Key Technical Specifications
(Standard dimensions for the 2018 Suzuki Alto rear brake drum across OEM and major aftermarket parts lines like ATE, TRW, and Blue Print):
-
Fitting Position: Rear Axle (Left & Right Sides)
-
Inner Diameter (Friction Surface): 180.0 mm
-
Outer Diameter: 208.0 mm
-
Total Drum Height: 63.0 mm
-
Working Face / Shoe Track Width: 34.5 mm – 35.0 mm
-
Number of Bolt/Stud Holes: 4 Holes
-
Bolt Hole Circle Diameter (PCD): 100.0 mm
-
Center Hub / Centering Diameter: 52.0 mm
-
Maximum Reboring / Wear Limit: 182.0 mm (The drum has reached its service limit and must be replaced if internal wear exceeds this diameter).
Material & Build Quality
-
Composition: Cast from high-grade grey cast iron, carefully balanced and engineered to withstand intense thermal expansion, friction heat, and mechanical stress without warping.
-
Surface Protection: Most modern aftermarket and OEM alternatives feature an anti-corrosion outer coating to prevent rust accumulation on non-friction exterior surfaces caused by road moisture and environmental elements.
Common OEM / Cross-Reference Numbers
-
Suzuki OEM Part Numbers: Frequently matches series designations like
43511-74P00,43511-84S00, or region-specific equivalents. -
Popular Aftermarket Equivalents: ATE (
24.0218-0039.1), Textar (94023900), and Blue Print.
Maintenance & Replacement Indicators
You should check or swap out the rear drums if you experience:
-
Scoring or Grooving: Deep, unpolished lines or ridges worn into the internal friction track.
-
Pedal/Handbrake Pulsation: Shuddering felt through the foot pedal or handbrake cable when slowing down.
-
Exceeded Wear Limit: If micrometer measurements show the inner diameter has worn past 182.0 mm, the structural wall is too thin and replacement is required for safe braking.







There are no reviews yet.